Dynfloat runs
For Dynfloat runs the following tabs are available:
- Run definition
- Signal selection
- Statistics
- Time traces
- Visualizer
- Output files
- View line shapes
| Include Page |
|---|
| Run definition |
|---|
| Run definition |
|---|
|
| Include Page |
|---|
| Dynfloat run definition |
|---|
| Dynfloat run definition |
|---|
|
| Include Page |
|---|
| Signal selection |
|---|
| Signal selection |
|---|
|
Visualizer
In this tab the simulation can be viewed as a 2D animation.
Above the plot there are options to manipulate the animation:
- Play ratio: this sets which frames are plotted. If it's 1 then each time step of the simulation is plotted, if it's 2 every second time step is plotted, etc.
- Generate echoes: when selected the contour of the vessel remains visible at the selected time rate. This helps viewing the envelope of the vessel's motions.
- Echo update rate: this sets the time rate at which the echoes are plotted.
At the centre bottom of the plot there are small buttons with which the view can be manipulated: zoom-in and -out (magnifying glass buttons), restore initial view (home button), panning (hand button) and rubber band zooming (rectangular-with-arrow button). Note that when the panning button is selected it replaces the rubber band zooming button and vice versa: only one of the two buttons is visible.
To the right of these buttons there is also a button with a camera: it allows saving the current view to a jpg-file.
In the bottom left corner of the panel there are the standard video playing buttons: start playing, pause and stop playing.
